Magicforce 68 Handwired

This firmware is for a Magicforce 68 that's had its PCB removed and is handwired with an Arduino Micro. NOTE: The Arduino Micro is different than the Arduino Pro Micro.

Keyboard Maintainer: The QMK Community
Hardware Supported: magicforce68, Arduino Micro

Wiring Layout

Pinout

The following pins are used:

• Columns 1-15: B2, B0, D3, D2, D1, D0, D4, C6, D7, E6, B4, B5, B6, B7, D6
• Rows 1-5: F0, F1, F4, F5, F6

Make example for this keyboard (after setting up your build environment):

make handwired/magicforce68:default

To flash the firmware onto the microcontroller, run make handwired/magicforce68:default:avrdude, and press the reset button.

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.